Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM

PRE-CRASH SAFETY SYSTEM > FAIL-SAFE CHART

for Preparation Click here



HINT:
The pre-crash system fail-safe function and details are indicated in the table below.

Cause
Warning Message
Fail-safe Operation
Conditions to Return to Normal Condition
A malfunction exists in part of pre-crash safety system
"CHECK PCS SYSTEM " to "PCS TEMPORARILY NOT AVAILABLE"
Depending on malfunction part, pre-crash seat belt or brake assist system may stop operating*2
Repair malfunctioning part
Radiator grille or millimeter wave radar sensor is dirty
"PCS TEMPORARILY NOT AVAILABLE"
Depending on dirty part, pre-crash seat belt or brake assist system may stop operating*2
Clean radiator grille or millimeter wave radar sensor
Pre-crash sensor cannot detect objects because of bad weather, such as snow
"PCS TEMPORARILY NOT AVAILABLE"
Depending on dirty part, pre-crash seat belt or brake assist system may stop operating*2
Sensor can detect objects
Overheating prevention function of seat belt control ECU operates*1
"PCS TEMPORARILY NOT AVAILABLE"
Pre-crash seat belt may stop operating
Temperature of seat belt goes down, and seat belt control ECU becomes operative

*1: The overheating prevention function operates when the seat belt control ECU detects a rise in seat belt temperature because of excessive seat belt operation.
*2: The pre-crash seat belts operate only with sudden braking.