Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM

WINDOW DEFOGGER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


  1. Disconnect the L17 air conditioning amplifier assembly connector.


    E124486E35

  2. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L17-1 (IG+) - L17-14 (GND)
    B - W-B
    Power source (IG)
    Power switch on (IG)
    11 to 14 V
    L17-1 (IG+) - L17-14 (GND)
    B - W-B
    Power source (IG)
    Power switch off
    Below 1 V
    L17-21 (B) - L17-14 (GND)
    Y - W-B
    Battery power supply
    Always
    11 to 14 V
    L17-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the L17 air conditioning amplifier assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L17-20 (RDEF) - L17-14 (GND)
    Y - W-B
    Rear window defogger signal
    Power switch on (IG), rear window defogger switch off
    11 to 14 V
    L17-20 (RDEF) - L17-14 (GND)
    Y - W-B
    Rear window defogger signal
    Power switch on (IG), rear window defogger switch on
    Below 1 V
    If the result is not as specified, the air conditioning amplifier assembly may have a malfunction.


CHECK AIR CONDITIONING CONTROL PANEL ASSEMBLY


  1. Disconnect the L20 air conditioning control panel assembly connector.


    E167392E07

  2. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L20-5 (IG+) - L20-8 (GND)
    B - W-B
    Power supply
    Power switch on (IG)
    11 to 14 V
    L20-8 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the L20 air conditioning control panel assembly connector.

  4. Check for pulses according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L20-2 (TX+) - L20-8 (GND)
    V - W-B
    Rear window defogger signal
    Power switch on (IG)
    Pulse generation
    If the result is not as specified, the air conditioning control panel assembly may have a malfunction.