REAR COIL SPRING > INSTALLATION |
| 1. INSTALL REAR UPPER COIL SPRING INSULATOR LH |
![]() |
Install the rear upper coil spring insulator LH to the rear coil spring LH.
| *1 | 10 mm or less |
| 2. INSTALL REAR UPPER COIL SPRING INSULATOR RH |
| 3. INSTALL REAR LOWER COIL SPRING INSULATOR LH |
| 4. INSTALL REAR LOWER COIL SPRING INSULATOR RH |
| 5. INSTALL REAR COIL SPRING LH |
Support the spring seat of the rear axle beam assembly using 2 jacks and 2 wooden blocks.

| *1 | Jack | *2 | Wooden Block |
Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks.
![]() |
Set the rear coil spring LH to the rear axle beam assembly.
| *1 | Identification Mark |
| *2 | 30° or less |
Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks and temporarily install the rear axle beam assembly and rear coil spring LH with the 2 bolts and 2 nuts.

| *1 | Jack | *2 | Wooden Block |
| 6. INSTALL REAR COIL SPRING RH |
| 7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ Height Control Sensor) |
![]() |
Install the rear height control sensor sub-assembly RH to the rear axle beam assembly with the bolt.
| 8. INSTALL REAR SPEED SENSOR WIRE (for LH Side) |
![]() |
Install the rear speed sensor wire to the rear axle beam assembly with the nut and 2 clamps.
| 9. INSTALL REAR SPEED SENSOR WIRE (for RH Side) |
| 10. CONNECT REAR SPEED SENSOR WIRE (for LH Side) |
![]() |
Connect the rear speed sensor wire connector to the rear speed sensor.
| 11. CONNECT REAR SPEED SENSOR WIRE (for RH Side) |
| 12. INSTALL REAR WHEELS |
| 13. STABILIZE SUSPENSION |
Lower the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
| 14. FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY |
![]() |
Fully tighten the 2 bolts.
| *1 | LH Side |
| *2 | RH Side |
![]() |
Fully tighten the 2 bolts.
| *1 | LH Side |
| *2 | RH Side |
| 15. INSTALL REAR WHEEL HOUSE LINER LH |
![]() |
Install the rear wheel house liner LH with the clip.
| 16. INSTALL REAR WHEEL HOUSE LINER RH |
| 17. INSPECT REAR WHEEL ALIGNMENT |
| 18. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 19. PERFORM YAW RATE AND ACCELERATION SENSOR CALIBRATION |
| 20. CHECK FOR SPEED SENSOR SIGNAL |
| 21. PERFORM INITIALIZATION (w/ Height Control Sensor) |