DTC B27A5 Open in Front Floor Electrical Key Oscillator Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B27A5 | Open circuit detected between the certification ECU (smart key ECU assembly) and indoor electrical key oscillator (for front floor) terminals (between CLG5 and CLG3, or CG5B and CLGB). |
|

| 1.CHECK CONNECTOR CONNECTION CONDITION |
Turn the power switch off.
Check that the connectors are properly connected to the certification ECU (smart key ECU assembly) and the indoor electrical key oscillator (for front floor).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - INDOOR ELECTRICAL KEY OSCILLATOR) |
Disconnect the certification ECU (smart key ECU assembly) connector.
![]() |
Disconnect the indoor electrical key oscillator (for front floor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-7 (CLG5) - L11-1 (CLG3) | Always | Below 1 Ω |
| L62-8 (CG5B) - L11-3 (CLGB) | Always | Below 1 Ω |
| L62-7 (CLG5) - Body ground | Always | 10 kΩ or higher |
| L62-8 (CG5B) - Body ground | Always | 10 kΩ or higher |
| L11-1 (CLG3) - Body ground | Always | 10 kΩ or higher |
| L11-3 (CLGB) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Indoor Electrical Key Oscillator (for Front Floor)) |
|
| ||||
| OK | |
| 3.INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (INDOOR ELECTRICAL KEY OSCILLATOR SIGNAL OUTPUT) |
![]() |
Reconnect the certification ECU (smart key ECU assembly) connector.
Measure the resistance and check for pulses according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-15 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| L62-7 (CLG5) - L62-15 (E) |
| No pulse generation |
| L62-7 (CLG5) - L62-15 (E) |
| Pulse generation |
| L62-8 (CG5B) - L62-15 (E) |
| No pulse generation |
| L62-8 (CG5B) - L62-15 (E) |
| Pulse generation |
| *1 | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | |
| 4.REPLACE INDOOR ELECTRICAL KEY OSCILLATOR (for Front Floor) |
Replace the indoor electrical key oscillator (for front floor) (Click here).
| NEXT | |
| 5.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||