DTC B2274 ACC Monitor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2274 | The ACC relay actuation circuit inside the power management control ECU or other related circuit is malfunctioning. |
|

| 1.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU) |
Disconnect the L5 and L6 connectors from the power management control ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L5-1 (AM22) - Body ground | Always | 9.5 to 16 V |
| L6-7 (AM21) - Body ground | Always | 9.5 to 16 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L5-5 (E01) - Body ground | Always | Below 1 Ω |
| L5-6 (E1) - Body ground | Always | Below 1 Ω |
| L6-4 (E12) - Body ground | Always | Below 1 Ω |
| L6-5 (E02) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2A-43 - 2B-4 | 20°C (68°F) | 81.49 to 118.98 Ω |
| 2A-43 - 2B-6 | 20°C (68°F) | 81.49 to 118.98 Ω |
| 2B-4 - 2B-6 | Always | Below 1 Ω |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - INSTRUMENT PANEL J/B) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L6-1 (ACCD) - 2A-43 | Always | Below 1 Ω |
| L6-1 (ACCD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BODY GROUND) |
Measure the resistance according to the value(s) the table below.
| Tester Connection | Condition | Specified Condition |
| 2B-4 - Body ground | Always | Below 1 Ω |
| 2B-6 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.INSPECT POWER MANAGEMENT CONTROL ECU |
![]() |
Reinstall the instrument panel junction block assembly.
Reconnect the L5 and L6 connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L6-1 (ACCD) - Body ground | Power switch on (ACC) | Output voltage at terminal AM21 or AM22 is -2.5 V or more |
| *1 | Component with harness connected (Power Management Control ECU) |
|
| ||||
| OK | ||
| ||