ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CHECK FOR INTERMITTENT PROBLEMS |
| CHECK FOR INTERMITTENT PROBLEMS |
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
![]() |
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Speed Open | Front speed sensor RH open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| FL Speed Open | Front speed sensor LH open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| RR Speed Open | Rear speed sensor RH open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| RL Speed Open | Rear speed sensor LH open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Yaw Rate Open | Yaw rate sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Deceleration Open | Acceleration sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Steering Open | Steering angle sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Master Cylinder Open | Regulator pressure sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Stroke Open | Brake pedal stroke sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| FR Wheel Cylinder Open | Wheel cylinder pressure sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| Accumulator Open | Accumulator pressure sensor open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
| HV Communication Open | Hybrid vehicle communication open detection / Error or Normal | Error: Momentary interruption Normal: Normal | - |
![]() |
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.