Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)

ENTRY AND START SYSTEM (for Start Function) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


Power Management Control ECU 
DTC Code
Detection Item
Trouble Area
See page
B2271
Ignition Hold Monitor Malfunction
1. AM2 fuse
2. IG1 relays
3. IG2 relay
4. Power management control ECU
5. Instrument panel junction block assembly
6. Wire harness or connector
Click here
B2274
ACC Monitor Malfunction
1. AM2 fuse
2. ACC relay
3. Power management control ECU
4. Instrument panel junction block assembly
5. Wire harness or connector
Click here
B2275
STSW Monitor Malfunction
1. AM2 fuse
2. Power management Control ECU
3. Wire harness or connector
Click here
B2277
Detecting Vehicle Submersion
Power management control ECU
Click here
B2282
Vehicle Speed Signal Malfunction
1. CAN communication system
2. Combination meter system
3. Power management control ECU
4. Wire harness or connector
Click here
B2284
Brake Signal Malfunction
1. STOP fuse
2. Stop light switch assembly
3. CAN communication system
4. Skid control ECU assembly
5. Power management control ECU
6. Wire harness or connector
Click here
B2286
Runnable Signal Malfunction
1. AM2 fuse
2. Power management control ECU
3. Wire harness or connector
Click here
U0293
Lost Communication with HV ECU
Power management control ECU
Click here