Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


    C250865E20
  1. Disconnect the R33 tire pressure warning ECU and receiver connector and measure the voltage and resistance on the wire harness side.
    Text in Illustration  
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and Receiver)

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R33-1 (IG) - R33-12 (GND)
    B - W-B
    IG power source
    Power switch on (IG)
    10 to 16 V
    R33-12 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

  2. Connect the R33 tire pressure warning ECU and receiver connector.



  3. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

    HINT:
    Inspect the connectors from the back side while the connectors are connected.


    E129452E78


    Text in Illustration  
    *a
    Component with harness connected
    (Tire Pressure Warning ECU and Receiver)
    -
    -

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R33-2 (SPD) - R33-12 (GND)
    V - W-B
    Vehicle speed signal
    Vehicle is running
    Pulse generation (see waveform 1)
    R33-3 (TC) - R33-12 (GND)
    L - W-B
    TC terminal
    Terminal TC is not connected
    11 to 14 V
    R33-5 (IND) - R33-12 (GND)
    G - W-B
    Tire pressure warning light output signal
    1. Power switch on (IG)
    2. Tire pressure warning light off
    3.2 V or higher
    1. Power switch on (IG)
    2. Tire pressure warning light on
    0.9 to 3.2 V
    R33-7 (CLSW) - R33-12 (GND)
    Y - W-B
    Tire pressure warning reset switch signal
    1. Power switch on (IG)
    2. Tire pressure warning reset switch on
    Below 1.5 V
    1. Power switch on (IG)
    2. Tire pressure warning reset switch off
    8 to 15 V
    R33-10 (SIL) - R33-12 (GND)
    P - W-B
    Diagnostic tester communication line
    Power switch on (IG)
    11 to 14 V



  4. A093224E40
  5. Using an oscilloscope, check waveform 1.
    Text in Illustration 
    *a
    GND
    Waveform 1: 
    Item
    Contents
    Terminal
    R33-2 (SPD) - R33-12 (GND)
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Vehicle condition
    Driving at 20 km/h (12 mph)

    HINT:
    The wavelength becomes shorter as the vehicle speed increases.