TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (ECU - AUXILIARY BATTERY AND BODY GROUND) |
![]() |
Disconnect the R33 tire pressure warning ECU and receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R33-1 (IG) - Body ground | Power switch on (IG) | 10 to 16 V |
| Power switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R33-12 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Tire Pressure Warning ECU and Receiver) |
|
| ||||
| OK | ||
| ||