DTC C2174/74 Vehicle Speed Signal Malfunction |
DTC C2191/91 Vehicle Speed Signal Error (Test Mode DTC) |
| DTC Code | Detection Condition | Trouble Area |
| C2174/74 | Vehicle speed signal malfunction |
|
| C2191/91 | Test mode procedure is performed |
|

| 1.READ VALUE USING DATA LIST (VEHICLE SPEED) |
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check that the values indicated on the GTS and on the combination meter are the same.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed reading/ min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) | Actual vehicle speed | Speed indicated on the combination meter assembly |
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (C2174/74) |
Perform a driving test.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC C2174/74 is not output | A |
| DTC C2174/74 is output | B |
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - JUNCTION BLOCK) |
Disconnect the R33 tire pressure warning ECU and receiver connector.
for LHD:
Disconnect the 3B No. 3 junction block connector.

for LHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R33-2 (SPD) - 3B-1 | Always | Below 1 Ω |
| R33-2 (SPD) or 3B-1 - Body ground | Always | 10 kΩ or higher |
| *A | for LHD |
| *a | Front view of wire harness connector (to No. 3 Junction Block) |
for RHD:
Disconnect the 4A No. 4 junction block connector.

for RHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R33-2 (SPD) - 4A-34 | Always | Below 1 Ω |
| R33-2 (SPD) or 4A-34 - Body ground | Always | 10 kΩ or higher |
| *A | for RHD |
| *a | Front view of wire harness connector (to No. 4 Junction Block) |
|
| ||||
| OK | ||
| ||
| 4.REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER |
Replace the tire pressure warning ECU and receiver (Click here).
| NEXT | |
| 5.REGISTRATION OF TRANSMITTER ID |
Perform registration (Click here).
| NEXT | |
| 6.PERFORM INITIALIZATION |
Perform initialization (Click here).
| NEXT | |
| 7.CHECK DTC OUTPUT (C2174/74) |
Perform a driving test.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC C2174/74 is output | A |
| DTC C2174/74 is not output | B |
|
| ||||
| A | ||
| ||