Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function)

ENTRY AND START SYSTEM (for Entry Function) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Entry & Start or Main Body / Data List.

  5. Read the Data List according to the display on the intelligent tester.

    Entry & Start (Certification ECU (Smart Key ECU Assembly)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D-Door Touch Sensor
    Driver side door touch sensor / ON or OFF
    ON: Sensor touched
    OFF: Sensor not touched
    -
    P-Door Touch Sensor*
    Front passenger side door touch sensor / ON or OFF
    ON: Sensor touched
    OFF: Sensor not touched
    -
    D-Door Trigger Switch
    Driver side door lock sensor / ON or OFF
    ON: Sensor touched
    OFF: Sensor not touched
    -
    P-Door Trigger Switch*
    Front passenger side door lock sensor / ON or OFF
    ON: Sensor touched
    OFF: Sensor not touched
    -
    Tr/B-Door Lock SW*
    Back door opener switch assembly (lock switch) / ON or OFF
    ON: Back door opener switch assembly (lock switch) pushed
    OFF: Back door opener switch assembly (lock switch) not pushed
    -
    Tr/B-Door Unlock SW*
    Back door opener switch assembly (opener switch) / ON or OFF
    ON: Back door opener switch assembly (opener switch) pushed
    OFF: Back door opener switch assembly (opener switch) not pushed
    -
    Ignition Switch
    Power switch on (IG) / ON or OFF
    ON: Power switch on (IG) or hybrid vehicle control system started
    OFF: Power switch off
    -
    Unmatched Vehicle-ID
    Communication condition between vehicle and key (vehicle-ID) / Yes or No
    Yes: Key ID code not matched to vehicle
    No: Key ID code matched to vehicle
    -
    No Response
    Communication condition between vehicle and key (response) / Yes or No
    Yes: Key ID code not matched to vehicle
    No: Key ID code matched to vehicle
    -
    Unmatch Code or Form
    Communication condition between vehicle and key (response code and format) / Yes or No
    Yes: Key ID code not matched to vehicle
    No: Key ID code matched to vehicle
    -
    Key Low Battery
    Low key battery / Yes or No
    Yes: Key battery voltage low
    No: Key battery voltage normal
    -
    Power Save Cnt 10 Min
    Power save counter - 10 minutes / Min: 0; Max: 255
    Within range from 0 to 255
    -
    Power Save Cnt 5 Day
    Power save counter - 5 days / Min: 0; Max: 255
    Within range from 0 to 255
    -
    Power Save Cnt 14 Day
    Power save counter - 14 days / Min: 0; Max: 255
    Within range from 0 to 255
    -
    ID Code Difference(Resp)
    Communication condition between vehicle and key (ID code) / Yes or No
    Yes: Key ID code not matched to vehicle
    No: Key ID code matched to vehicle
    -
    C Code Difference
    Communication condition between vehicle and key (challenge code) / Yes or No
    Yes: Key ID code not matched to vehicle
    No: Key ID code matched to vehicle
    -
    Auto Entry Cancel SW
    Entry function cancel / ON or OFF
    Mode status displayed
    -
    Ignition Available Area
    Ignition available area / Front or All
    Customization status displayed
    -
    Parking Wait Time
    Parking wait time / 0.5s, 1.5s, 2.5s or 5s
    Customization status displayed
    -
    B-Dr Opening Operation*
    Back door opening operation / Long, Twice or OFF
    Customization status displayed
    -
    Key Low Battery Warning
    Low key battery warning / ON or OFF
    Customization status displayed
    -
    *: w/ Entry System Back Door Open Function

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Power switch on (ACC) / ON or OFF
    ON: Power switch on (ACC)
    OFF: Power switch off
    -
    IG SW
    Power switch on (IG) / ON or OFF
    ON: Power switch on (IG)
    OFF: Power switch off
    -
    RR Door Courtesy SW
    Rear door courtesy light switch signal/ON or OFF
    ON: Rear door RH or LH open
    OFF: Rear door RH and LH closed
    -
    RL Door Courtesy SW
    Rear door courtesy light switch signal/ON or OFF
    ON: Rear door RH or LH open
    OFF: Rear door RH and LH closed
    -
    Back Door Courtesy SW
    Back door courtesy switch signal/ON or OFF
    ON: Back door open
    OFF: Back door closed
    -
    Back Door Open
    Back door lock/Permit or Prohibit
    Permit: Back door unlocked
    Prohibit: Back door locked
    -
    Door Lock SW-Lock
    Front passenger side door control switch lock signal/ON or OFF
    ON: Lock side of front passenger side door control switch pushed
    OFF: Lock side of front passenger side door control switch not pushed
    -
    Door Lock SW-Unlock
    Front passenger side door control switch unlock signal/ON or OFF
    ON: Unlock side of front passenger side door control switch pushed
    OFF: Unlock side of front passenger side door control switch not pushed
    -
    Door Key SW-Lock
    Driver door key-linked lock/unlock switch lock signal/ON or OFF
    ON: Driver door key cylinder turned to lock position
    OFF: Driver door key cylinder not turned to lock position
    -
    D Door Key SW-UL
    Driver door key-linked lock/unlock switch unlock signal/ON or OFF
    ON: Driver door key cylinder turned to unlock position
    OFF: Driver door key cylinder not turned to unlock position
    -
    FR Door Lock Pos
    Front passenger side door lock position switch signal/LOCK or UNLOCK
    LOCK: Front passenger side door locked
    UNLOCK: Front passenger side door unlocked
    -
    FR Door Courtesy
    Front passenger side door courtesy light switch signal/ON or OFF
    ON: Front passenger side door open
    OFF: Front passenger side door closed
    -
    FL Door Lock Pos
    Driver door lock position switch signal/LOCK or UNLOCK
    LOCK: Driver door locked
    UNLOCK: Driver door unlocked
    -
    FL Door Courtesy
    Driver door courtesy light switch signal/ON or OFF
    ON: Driver door open
    OFF: Driver door closed
    -
    Back Door Open Handle SW
    Back door opener switch signal/ON or OFF
    ON: Back door opener switch pushed
    OFF: Back door opener switch not pushed
    -
    RR-Door Lock Pos SW
    Rear door lock position switch signal/LOCK or UNLOCK
    LOCK: Rear door RH or LH locked
    UNLOCK: Rear door RH and LH unlocked
    -
    RL-Door Lock Pos SW
    Rear door lock position switch signal/LOCK or UNLOCK
    LOCK: Rear door RH or LH locked
    UNLOCK: Rear door RH and LH unlocked
    -


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Entry & Start or Main Body / Active Test.

  5. Perform the Active Test according to the display on the intelligent tester.

    Entry & Start (Certification ECU (Smart Key ECU Assembly)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Overhead Tuner Power Supply ON
    Door control receiver assembly
    ON/OFF
    -
    *: w/ Entry System Back Door Open Function

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Trunk and Back-door Open
    Back door lock motor
    ON/OFF
    -