DTC P0AA7-727 Hybrid Battery Voltage Isolation Sensor Circuit |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0AA7 | 727 | Malfunction in the insulation monitoring circuit in the battery smart unit | Battery smart unit |
| 1.CLEAR DTC |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Clear DTCs and freeze frame data.
| NEXT | |
| 2.SIMULATION TEST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG) and wait for 1 minute or more.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P0AA7-727 is not output | A |
| P0AA7-727 is output | B |
|
| ||||
| A | |
| 3.SIMULATION TEST |
With the vehicle and engine stopped, turn the power switch on (READY) with park (P) selected and wait for 1 minute or more. (If the engine starts, wait until the engine stops.)
While depressing the brake pedal without depressing the accelerator pedal, move the shift lever to D and wait for 1 minute.
Drive the vehicle 50 cm (1.64 ft.) forward.
While depressing the brake pedal without depressing the accelerator pedal, wait for 1 minute. (Step A)
Drive the vehicle another 50 cm (1.64 ft.) forward and perform step A. Repeat this procedure 5 times (minimum total driving distance: 2 m (6.56 ft.)).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P0AA6 is not output | A |
| P0AA6 is output | B |
|
| ||||
| A | ||
| ||