HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL |
| 1. REMOVE FRONT WHEEL LH (for LHD) |
| 2. REMOVE FRONT WHEEL RH (for RHD) |
| 3. REMOVE FRONT FENDER LINER LH (for LHD) |
| 4. REMOVE FRONT FENDER LINER RH (for RHD) |
![]() |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the 10 clips and 4 screws.
Using a clip remover, remove the grommet and the front fender liner RH.
| 5. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim sub-assembly LH.
| 7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY |
![]() |
Remove the screw <C>.
![]() |
Disengage the 6 claws and clip as shown in the illustration.
![]() |
Disengage the claw and 2 guides and disconnect the hood lock control cable.
Disconnect each connector and clamp, and remove the lower instrument panel finish panel assembly.
| 8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.
| 9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) |
![]() |
Disconnect the hood lock control cable assembly.
Using a screwdriver, disengage each clamp shown in the illustration.

| *1 | Hood Lock Control Cable | *2 | Grommet |
| *3 | Hood Cable Grommet | - | - |
Pull the hood lock control cable assembly from the engine compartment and remove it.
| 10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) |
![]() |
Disconnect the hood lock control cable assembly.
Using a screwdriver, disengage each clamp shown in the illustration.

| *1 | Hood Lock Control Cable | *2 | Grommet |
| *3 | Hood Cable Grommet | - | - |
Pull the hood lock control cable assembly from the engine compartment and remove it.