ENTRY AND START SYSTEM (for Start Function) > PRECAUTION |
| 1.WHEN DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| System Name | See Procedure |
| Intelligent Parking Assist System |
Click here
|
The power source mode (off, on (ACC), on (IG)) is always retained in memory by the vehicle. If the auxiliary battery is disconnected, the power source mode that was present before disconnection will be restored after the auxiliary battery is reconnected. Be sure to turn the power switch off (change the power source mode to off) before disconnecting the cable from the negative (-) auxiliary battery terminal. Be careful if the power source mode of a vehicle with a discharged auxiliary battery is not known.
After the cable is reconnected to the negative (-) auxiliary battery terminal, the hybrid control system may not start on the first attempt. This is not a malfunction. The hybrid control system will start normally for subsequent attempts.
| 2.PRECAUTIONS FOR PUSH-BUTTON START FUNCTION |
Before starting hybrid control system, firmly depress the brake pedal until the indicator in the power switch turns green.
The entry and start system, wireless door lock control system and engine immobiliser system may not operate normally, or the size of the operation area may decrease in the following situations:
When the smart key battery is depleted.
When any facility that generates strong radio waves or electrical noise such as a TV tower, power plant, gas station, broadcast station, large video-billboard or airport are located near the inspection site.
When the key is located near a wireless device such as a radio, cellular phone or cordless telephone.
When the smart key is in contact with or covered with a metal object similar to the following:
When a wireless remote is operated near the vehicle.
When the key is carried with following items:
When a metallic film is applied to the rear glass.
| 3.WHEN KEY BATTERY IS LOW |
When the key battery is depleted, the hybrid control system cannot be started using the smart function. For how to start the hybrid control system when the key battery is depleted, see Description (Click here).
If the electrical key is held near the power switch to start the hybrid control system when the electrical key battery is depleted, the following warnings will sound:
Driver door open → closed
Doors other than the driver door open → closed
| 4.EMERGENCY HYBRID CONTROL SYSTEM STOP CONTROL |
If it is necessary to stop the hybrid control system in an emergency while driving the vehicle, push and hold the power switch for more than 3 seconds.
While driving, the power switch should only be operated in the event of on emergency.
| 5.EMERGENCY HYBRID CONTROL SYSTEM START CONTROL |
If there is a malfunction in the stop light switch or STOP fuse, their signals may not be correctly transmitted to the power management control ECU. This may result in the hybrid control system not starting even if the power switch is pressed while the brake pedal is depressed and park (P) is selected.
To activate the hybrid control system:
Push the P position switch.
Parking brake pedal is depressed.
Turn the power switch from off to on (ACC).
Brake pedal is depressed.
Press and hold the power switch for 15 seconds or more.