ENTRY AND START SYSTEM (for Start Function) > ON-VEHICLE INSPECTION |
| 1. CHECK POWER SOURCE MODE CHANGE FUNCTION |
Check the function of the power switch.
Check that power source mode changes in accordance with the conditions of the shift position and brake pedal.
| Brake Pedal | Shift Lever | Power Source Mode Pattern |
| Depressed | P | When the power switch is pushed once.
|
| Not depressed | P | Each time the power switch is pushed.
|
| Except P | Each time the power switch is pushed.
| |
| - | P | When the power switch is pushed in the on (READY) condition.
|
| - | Except P | When the power switch is pushed in the on (READY) condition.
|
Check that the power source mode changes without pressing the power switch.
With power source mode on (ACC) or on (IG) and with park (P) selected, wait for at least 1 hour. Check that the power source mode changes from on (ACC) or on (IG) to off automatically.
| 2. CHECK INDICATOR CONDITION |
![]() |
Check the indicator light on the power switch.
Check that the power switch indicator turns on and changes color according to the table below.
| Power Source Mode/Condition | Indicator Light Condition | |
| Brake Pedal Released | Brake Pedal Depressed, Park (P) selected | |
| off | off | Turns on (Green) |
| on (ACC, IG) | Turns on (Amber) | Turns on (Green) |
| on (READY) | off | off |
| System malfunction | Flashes (Amber) for 15 sec. | Flashes (Amber) for 15 sec. |