Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connectors under the seat.

  1. Connect the cable to the auxiliary negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the power seat switch knob and move the seat to the rearmost position.



    B302426E01
  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.

  1. Operate the power seat switch knob and move the seat to the foremost position.



    B302425E01
  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



2. INSTALL INNER SEAT TRACK COVER
  1. Engage the 2 claws to install the inner seat track cover.



3. INSTALL OUTER SEAT TRACK COVER
  1. Engage the 2 claws to install the outer seat track cover.



4. INSTALL FRONT SEAT HEADREST ASSEMBLY


5. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



6. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



7. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



8. INSPECT FRONT SEAT ASSEMBLY
  1. Check the power seat operation (Click here).

  1. Check the seat heater operation.

    1. Turn the power switch on.

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.



9. INSPECT SRS WARNING LIGHT
(Click here)