LUMBAR SWITCH (for Manual Seat) > INSTALLATION |
| 1. INSTALL LUMBAR SWITCH |
![]() |
Install the lumbar switch with the 2 screws.
| 2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY |
![]() |
Disengage the 5 clamps.
Connect the connector.
![]() |
Engage the clip and 2 claws.
Install the front seat cushion shield assembly with the screw.
| 3. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster) |
![]() |
Install the vertical adjusting handle with the screw.
| 4. INSTALL RECLINING ADJUSTER RELEASE HANDLE |
![]() |
Engage the claw and install the reclining adjuster release handle.
| 5. INSTALL FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
Connect the connectors under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Tighten the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Tighten the 2 bolts on the rear side of the seat.
| 6. INSTALL INNER SEAT TRACK COVER |
![]() |
Engage the claw and guide and install the inner seat track cover.
| 7. INSTALL OUTER SEAT TRACK COVER |
![]() |
Engage the 2 claws and install the outer seat track cover.
| 8. INSTALL FRONT SEAT HEADREST ASSEMBLY |
![]() |
Install the front seat headrest assembly as shown in the illustration.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 11. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 12. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 13. INSPECT FRONT SEAT ASSEMBLY |
Place the front seat assembly in the cabin.
Connect the connectors under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Tighten the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Tighten the 2 bolts on the rear side of the seat.
| 14. INSPECT SRS WARNING LIGHT |