DTC P0571 Brake Switch "A" Circuit |
| DTC | DTC Detection Condition | Trouble Area |
| P0571 | Voltage of STP signal and that of ST1- signal of power management control ECU are less than 1 V for 0.5 seconds or more |
|

| 1.INSPECT STOP LIGHT SWITCH ASSEMBLY (POWER SOURCE) |
![]() |
Disconnect the stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-2 - Body ground | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY (POWER SOURCE) |
![]() |
Disconnect the stop light switch assembly connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A26-4 - Body ground | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch Assembly) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| 1 - 2 | Switch pin pushed | 10 kΩ or higher |
| 3 - 4 | Switch pin pushed | Below 1 Ω |
| *1 | Component without harness connected (Stop Light Switch Assembly) |
| *2 | Not pushed |
| *3 | Pushed |
Reinstall the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - STOP LIGHT SWITCH ASSEMBLY) |
![]() |
Disconnect the power management control ECU connector.
Disconnect the stop light switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A22-23 (STP) - A26-1 | Always | Below 1 Ω |
| A22-7 (ST1-) - A26-3 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A22-23 (STP) or A26-1 - Body ground | Always | 10 kΩ or higher |
| A22-7 (ST1-) or A26-3 - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Stop Light Switch Assembly) |
| *2 | Front view of wire harness connector (to Power Management Control ECU) |
Reconnect the stop light switch assembly connector.
Reconnect the power management control ECU connector.
|
| ||||
| OK | ||
| ||