DTC P0575 Cruise Control Input Circuit |
| DTC | DTC Detection Condition | Trouble Area |
| P0575 | When both of the following conditions are met:
| Power management control ECU |
| 1.READ OUTPUT DTC (P0575) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Clear the DTC (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch (ON-OFF button) on.
Push the -SET button to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0575 is output | B |
|
| ||||
| A | ||
| ||