Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power for main body ECU (multiplex network body ECU) operation.

WIRING DIAGRAM


B231170E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Disconnect the 2B, 2C and 2F instrument panel junction block assembly and A main body ECU (multiplex network body ECU) connectors.


    B220556E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2B-6 - A-11 (GND1)
    Always
    Below 1 Ω
    2C-18 - A-30 (BECU)
    Always
    Below 1 Ω
    2F-1 - A-31 (ALTB)
    Always
    Below 1 Ω


    Text in Illustration 
    *1
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    *2
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    *3
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    *4
    Front view of wire harness connector
    (to Main Body ECU (Multiplex Network Body ECU))



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - AUXILIARY BATTERY)


    B230728E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2F-1 - Body ground
    Always
    11 to 14 V
    2C-18 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)
    *2
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND)


    E173019E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2B-6 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)