THEFT DETERRENT SYSTEM > ECU Power Source Circuit |

| 1.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Disconnect the 2B, 2C and 2F instrument panel junction block assembly and A main body ECU (multiplex network body ECU) connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2B-6 - A-11 (GND1) | Always | Below 1 Ω |
| 2C-18 - A-30 (BECU) | Always | Below 1 Ω |
| 2F-1 - A-31 (ALTB) | Always | Below 1 Ω |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) | *2 | Component without harness connected (Instrument Panel Junction Block Assembly) |
| *3 | Component without harness connected (Instrument Panel Junction Block Assembly) | *4 | Front view of wire harness connector (to Main Body ECU (Multiplex Network Body ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - AUXILIARY BATTERY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2F-1 - Body ground | Always | 11 to 14 V |
| 2C-18 - Body ground | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
| *2 | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2B-6 - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | ||
| ||