NAVIGATION SYSTEM (for DVD) > DTC CHECK / CLEAR |
| CHECK DTC (CHECK USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Navigation System / DTC.
Check for DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (CHECK USING INTELLIGENT TESTER) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Navigation System / DTC.
Clear the DTCs.
| START DIAGNOSTIC MODE |
There are 2 methods to start diagnostic mode. Start the mode by using either of them.
![]() |
Method 1
Start the hybrid system.
While pressing and holding the "INFO" switch, operate the light control switch: off → Turn on → Turn off → Turn on → Turn off → Turn on → Turn off.
Diagnostic mode starts and the "Service Menu" screen will be displayed. Service inspection starts automatically and the result will be displayed.
Method 2
Start the hybrid system.
Press the "DISP" switch.
![]() ![]() |
From the display quality adjustment screen, touch the corners of the screen in the following order: Upper left → Lower left → Upper left → Lower left → Upper left → Lower left.
Diagnostic mode starts and the "Service Menu" screen will be displayed.
| FINISH DIAGNOSTIC MODE |
Turn the power switch off.
| FAILURE DIAGNOSIS |
![]() |
The "Failure Diagnosis" screen will be displayed by pressing the "Failure Diagnosis" switch on the "Service Menu" screen.
| SYSTEM CHECK |
![]() |
The "System Check Mode" screen will be displayed by pressing the "System Check" switch on the "Failure Diagnosis" screen.
| CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN) |
![]() |
Read the system check result.
If the check result is "EXCH" or "CHEK", touch the displayed check result to view the results on the "Unit Check Mode" screen and record them.
Check the details of the DTC(s) (Click here).
| System | Proceed to |
| Intelligent parking assist system |
Click here
|
| DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN) |
![]() |
Clear DTC
Press the "Memory CLR" switch for 3 seconds.
Confirm that the check results are cleared.
![]() |
Recheck
Press the "Recheck" switch.
![]() |
Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.