LIGHTING SYSTEM > Front Fog Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Front Fog Light Relay | Front fog light relay | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK OPERATION (TAILLIGHTS) |
Check the operation of the taillights.
|
| ||||
| OK | |
| 3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly.
Connect a positive (+) lead from the battery to terminal 2E-1or 2F-1.
Connect a negative (-) lead from the battery to terminals A-14 and A-13.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2C-8 - Battery negative | Always | 11 to 14 V |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) |
| *2 | for LHD |
| *3 | for RHD |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BULB - INSTRUMENT PANEL JUNCTION BLOCK AND BODY GROUND) |
Disconnect the 2C instrument panel junction block assembly connector.
Disconnect the C4 or C6 fog light assembly connector.
Measure the resistance to the according value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C4-2 - 2C-8 | Always | Below 1 Ω |
| C6-2 - 2C-8 | Always | Below 1 Ω |
| 2C-8 - Body ground | Always | 10 kΩ or higher |
| C4-1 - Body ground | Always | Below 1 Ω |
| C6-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||