POWER MIRROR CONTROL SYSTEM > TERMINALS OF ECU |
| CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY |
Disconnect the L17 air conditioning amplifier assembly connector.

Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L17-1 (IG+) - L17-14 (GND) | B - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| L17-1 (IG+) - L17-14 (GND) | B - W-B | Power source (IG) | Power switch off | Below 1 V |
| L17-21 (B) - L17-14 (GND) | Y - W-B | Battery power supply | Always | 11 to 14 V |
| L17-14 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the L17 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L17-20 (RDEF) - L17-14 (GND) | Y - W-B | Rear window defogger signal | Power switch on (IG), rear window defogger switch off | 11 to 14 V |
| L17-20 (RDEF) - L17-14 (GND) | Y - W-B | Rear window defogger signal | Power switch on (IG), rear window defogger switch on | Below 1 V |
| CHECK AIR CONDITIONING CONTROL PANEL ASSEMBLY |
Disconnect the L20 air conditioning control panel assembly connector.

Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L20-5 (IG+) - L20-8 (GND) | B - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| L20-8 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the L20 air conditioning control panel assembly connector.
Check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L20-2 (TX+) - L20-8 (GND) | V - W-B | Rear window defogger signal | Power switch on (IG) | Pulse generation |