Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY (for LH Side)

REAR SEAT INNER BELT ASSEMBLY (for LH Side) > INSPECTION

for Preparation Click here



1. INSPECT REAR SEAT INNER BELT ASSEMBLY (for LH Side)


B202371E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (LBR+) - 2 (E)
    Rear seat belt LH fastened
    Below 1 Ω
    1 (LBR+) - 2 (E)
    Rear seat belt LH not fastened
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Rear Seat Inner Belt Assembly (LH Side and Center))
    If the result is not as specified, replace the rear seat inner belt assembly (LH side and center).



2. INSPECT REAR SEAT INNER BELT ASSEMBLY (for Center)


B230306E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (CBR+) - 2 (E)
    Rear center seat belt fastened
    Below 1 Ω
    1 (CBR+) - 2 (E)
    Rear center seat belt not fastened
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Rear Seat Inner Belt Assembly (LH Side and Center))
    If the result is not as specified, replace the rear seat inner belt assembly (LH side and center).