DRIVING SUPPORT ECU > INSTALLATION |
| 1. INSTALL DRIVING SUPPORT ECU (for LHD) |
![]() |
Install the driving support ECU with the nut.
![]() |
Connect the connector.
| 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD) |
![]() |
With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
| *a | Opened Approximately 55° |
| *b | Closed |
![]() |
Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
| *1 | Glove Compartment Door Stopper Sub-assembly |
| *2 | Stopper |
Engage the claw and connect the glove compartment door stopper sub-assembly.
| 3. INSTALL DRIVING SUPPORT ECU (for RHD) |
![]() |
Install the driving support ECU with the nut.
![]() |
Connect the connector.
| 4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD) |
| 5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD) |
| 6. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD) |