Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU

DRIVING SUPPORT ECU > INSTALLATION

for Preparation Click here



1. INSTALL DRIVING SUPPORT ECU (for LHD)


    E186385
  1. Install the driving support ECU with the nut.

    NOTICE:
    Do not install the driving support ECU if it has been damaged or impacted in any way.



    E186386
  1. Connect the connector.



2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    B223650E01
  1. With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
    Text in Illustration 
    *a
    Opened Approximately 55°
    *b
    Closed

    NOTICE:
    Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.



    B223648E01
  1. Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Engage the claw and connect the glove compartment door stopper sub-assembly.



3. INSTALL DRIVING SUPPORT ECU (for RHD)


    E186308
  1. Install the driving support ECU with the nut.



    E186307
  1. Connect the connector.



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)

HINT:
Use the same procedure described for the LH side .



5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:
Use the same procedure described for the LH side .



6. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:
Use the same procedure described for the LH side .