DRIVING SUPPORT ECU > REMOVAL |
| 1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD) |
![]() |
Disengage the claw and release the glove compartment door stopper.
| *1 | Glove Compartment Door Stopper Sub-assembly |
| *2 | Stopper |
Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.
![]() |
Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.
| *a | Close |
| *b | Open Approximately |
| 2. REMOVE DRIVING SUPPORT ECU (for LHD) |
![]() |
Disconnect the connector.
![]() |
Remove the nut and driving support ECU.
| 3. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD) |
| 4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD) |
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD) |
| 6. REMOVE DRIVING SUPPORT ECU (for RHD) |
![]() |
Disconnect the connector.
![]() |
Remove the nut and driving support ECU.