Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU

DRIVING SUPPORT ECU > REMOVAL

for Preparation Click here



1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    B223647E01
  1. Disengage the claw and release the glove compartment door stopper.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.



    B223649E01
  1. Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.
    Text in Illustration 
    *a
    Close
    *b
    Open Approximately

    NOTICE:
    Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.



2. REMOVE DRIVING SUPPORT ECU (for LHD)


    E186386
  1. Disconnect the connector.



    E186385
  1. Remove the nut and driving support ECU.



3. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:
Use the same procedure described for the LH side .



4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

HINT:
Use the same procedure described for the LH side .



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)

HINT:
Use the same procedure described for the LH side .



6. REMOVE DRIVING SUPPORT ECU (for RHD)


    E186307
  1. Disconnect the connector.



    E186308
  1. Remove the nut and driving support ECU.