AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit |

| 1.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L34-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L34-4 (B) - L34-7 (GND) | Power switch off | 11 to 14 V |
| L34-3 (ACC) - L34-7 (GND) | Power switch on (ACC) | 11 to 14 V |
| *1 | Front view of wire harness connector (to Radio Receiver Assembly) |
|
| ||||
| OK | ||
| ||