Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

DTC    B2761    Intrusion Sensor Internal Circuit Malfunction

for Preparation Click here


DESCRIPTION

  1. The theft warning radar sensor (intrusion sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
    If a problem is detected in the signals the theft warning radar sensor (intrusion sensor) transmits and receives in the vehicle, or if the transmission or reception circuits malfunction, the theft warning radar sensor (intrusion sensor) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B2761
Intrusion sensor outputs signal for sensor malfunction
  1. Theft warning radar sensor (intrusion sensor)
  2. Main body ECU (multiplex network body ECU)

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Set the theft deterrent system and check if the same DTC is not output (Click here).

    OK:
    DTC B2761 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.REPLACE THEFT WARNING RADAR SENSOR (INTRUSION SENSOR)
  1. Replace the theft warning radar sensor (intrusion sensor) (Click here).


NEXT


3.CHECK FOR DTC
  1. Check if DTC B2761 is not output (Click here).

    OK:
    DTC B2761 is not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (THEFT WARNING RADAR SENSOR (INTRUSION SENSOR) WAS FAULTY)