Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU

for Preparation Click here



REAR TELEVISION CAMERA ASSEMBLY

E228118E04

  1. Disconnect the V6 connector from the rear television camera assembly.

  2. Measure the voltage of each terminal of the wire harness side connector.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    V6-3 (CGND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 V
    V6-4 (CB+) - V6-3 (CGND)
    W - W-B
    Power source
    Power switch on (READY)
    Reverse (R) selected
    5.5 to 7.05 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the V6 connector to the rear television camera assembly.

  4. Check for pulses between each terminal of the connector.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    V6-2 (CV+) - V6-1 (CV-)
    R - B
    Video signal
    Power switch on (READY)
    Reverse (R) selected
    Camera lens not covered, displaying an image
    Pulse generation
    (See waveform 1)
    Power switch on (READY)
    Reverse (R) selected
    Camera lens covered, blacking out screen
    Pulse generation
    (See waveform 2)
    If the result is not as specified, the rear television camera assembly may have a malfunction.



  5. E171712E22
  6. Reference (Oscilloscope waveform):

    1. Waveform 1 (camera lens is not covered, displaying an image)
      Item
      Content
      Terminal No. (Symbol)
      V6-2 (CV+) - V6-1 (CV-)
      Tool Setting
      200 mV/DIV., 50 μs/DIV.
      Condition
      Power switch on (READY), reverse (R) selected

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

    2. Waveform 2 (camera lens is covered, blacking out the screen)
      Item
      Content
      Terminal No. (Symbol)
      V6-2 (CV+) - V6-1 (CV-)
      Tool Setting
      200 mV/DIV., 50 μs/DIV.
      Condition
      Power switch on (READY), reverse (R) selected

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1 (camera lens not covered, displaying an image)
      *b
      Waveform 2 (camera lens covered, blacking out the screen)
      *c
      Synchronization Signal
      *d
      Video Waveform


RADIO AND DISPLAY RECEIVER ASSEMBLY (NAVIGATION SYSTEM (for Radio and Display Type) (Click here)

RADIO AND DISPLAY RECEIVER ASSEMBLY (for Audio and Visual System) (Click here)