SEAT BELT WARNING SYSTEM > TERMINALS OF ECU |
| COMBINATION METER ASSEMBLY |
Disconnect the L27 combination meter assembly connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L27-24 (SW) - Body ground | P - Body ground | Front passenger side seat belt buckle switch signal | Front passenger side seat occupied, seat belt fastened | 10 kΩ or higher |
| L27-24 (SW) - Body ground | P - Body ground | Front passenger side seat belt buckle switch signal | Front passenger side seat occupied, seat belt unfastened | Below 1 Ω |
| L27-30 (ES) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the L27 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| F27-19 (IG+) - Body ground | L - Body ground | Power switch power supply | Power switch off | Below 1 V |
| F27-19 (IG+) - Body ground | L - Body ground | Power switch power supply | Power switch on (IG) | 11 to 14 V |
| F27-21 (PBLT) - Body ground | Y - Body ground | Front passenger side seat belt warning light signal | Power switch on (IG), front passenger side seat occupied, seat belt fastened | 11 to 14 V |
| F27-21 (PBLT) - Body ground | Y - Body ground | Front passenger side seat belt warning light signal | Power switch on (IG), front passenger side seat occupied, seat belt unfastened | Alternates between 11 to 14 V and below 1 V |
| PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY |

Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| M2-6 (IG+) - Body ground | L - Body ground | Power switch power supply | Power switch on (IG) | 11 to 14 V |
| M2-6 (IG+) - Body ground | L - Body ground | Power switch power supply | Power switch off | Below 1 V |
| M2-3 (PBEW) - Body ground | W - Body ground | Front passenger side seat belt warning light signal | Front passenger side seat occupied, seat belt fastened | 11 to 14 V |
| M2-3 (PBEW) - Body ground | W - Body ground | Front passenger side seat belt warning light signal | Front passenger side seat occupied, seat belt unfastened | Alternates between 11 to 14 V and below 1 V |
| MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |

Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| L7-6 (LRCY) - Body ground | G - Body ground | Rear door courtesy light switch input | Rear door LH or RH open | Below 1 V |
| L7-6 (LRCY) - Body ground | G - Body ground | Rear door courtesy light switch input | Rear door LH and RH closed | 11 to 14 V |
| 2B-14 (DBKL) - Body ground | P - Body ground | Driver side seat belt buckle | Driver side seat belt fastened | Below 1 V |
| 2B-14 (DBKL) - Body ground | P - Body ground | Driver side seat belt buckle | Driver side seat belt unfastened | 11 to 14 V |