Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


  1. Inspect outer mirror motor operation.



      B225736E01
    1. Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 7 (M+)
      Battery negative (-) → Terminal 3 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MV)
      Battery negative (-) → Terminal 7 (M+)
      Turns upward
      Battery positive (+) → Terminal 6 (MH)
      Battery negative (-) → Terminal 7 (MV+
      Turns left
      Battery positive (+) → Terminal 7 (M+)
      Battery negative (-) → Terminal 6 (MH)
      Turns right

      Text in Illustration 
      *1
      Component without harness connected
      (Outer Rear View Mirror Assembly LH)
      If the result is not as specified, replace the outer rear view mirror assembly LH.

  1. Check the mirror heater (w/ Mirror heater).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Terminal 1 (HL-) - Terminal 2 (HL+)
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror assembly.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


  1. Inspect outer mirror motor operation.



      B225735E01
    1. Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 7 (M+)
      Battery negative (-) → Terminal 3 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MV)
      Battery negative (-) → Terminal 7 (M+)
      Turns upward
      Battery positive (+) → Terminal 6 (MH)
      Battery negative (-) → Terminal 7 (M+)
      Turns left
      Battery positive (+) → Terminal 7 (M+)
      Battery negative (-) → Terminal 6 (MH)
      Turns right

      Text in Illustration 
      *1
      Component without harness connected
      (Outer Rear View Mirror Assembly RH)
      If the result is not as specified, replace the outer rear view mirror assembly RH.

  1. Check the mirror heater (w/ Mirror heater).

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Terminal 1 (HR-) - Terminal 2 (HR+)
      25°C (77°F)
      7.6 to 11.4 Ω

      If the result is not as specified, replace the outer rear view mirror assembly.