Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


    E133257E06
  1. Connect a (+) lead from the battery to terminal 1 and a (-) lead to terminal 4.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Position
    Specified Condition
    (Battery voltage is 12 V)
    2 - 1
    0
    9.48 to 10.2 V
    (0.5)
    8.77 to 9.49 V
    1
    8.06 to 8.78 V
    (1.5)
    7.36 to 8.08 V
    2
    6.65 to 7.37 V
    (2.5)
    5.94 to 6.66 V
    3
    5.23 to 5.95 V
    (3.5)
    4.52 to 5.24 V
    4
    3.82 to 4.54 V
    (4.5)
    3.1 to 3.83 V
    5
    2.4 to 3.12 V

    If the result is not as specified, replace the switch.

  1. Connect a (+) lead from the battery to terminal 3 and a (-) lead to terminal 4.

  1. Check that the illumination of the switch comes on.

    OK:
    The illumination comes on.

    Text in Illustration 
    *1
    Component without harness connected
    (Headlight Leveling Switch)
    If the result is not as specified, replace the switch.