Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH

TRIP SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TRIP SWITCH


E192285E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (CS) - 12 (E)
    Unit change switch pressed
    Below 1 Ω
    1 (CS) - 12 (E)
    Unit change switch not pressed
    10 kΩ or higher
    9 (HOUR) - 12 (E)
    Hour adjust switch pressed
    Below 1 Ω
    9 (HOUR) - 12 (E)
    Hour adjust switch not pressed
    10 kΩ or higher
    10 (MIN) - 12 (E)
    Minute adjust switch pressed
    Below 1 Ω
    10 (MIN) - 12 (E)
    Minute adjust switch not pressed
    10 kΩ or higher
    11 (RST) - 12 (E)
    Set switch pressed
    Below 1 Ω
    11 (RST) - 12 (E)
    Set switch not pressed
    10 kΩ or higher

  1. Apply battery voltage from the wire harness back side between the terminals of the switch, and check the lighting condition of the trip switch.

    OK:
    Measurement Condition
    Condition
    Specified Condition
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 4 (E)
    Always
    Trip switch illuminates

    Text in Illustration 
    *1
    Trip Switch (for RHD)
    *2
    Trip Switch (for LHD)
    *1
    Component without harness connected
    (Trip Switch)
    If the result is not as specified, replace the trip switch (Click here).