NAVIGATION SYSTEM (for DVD) > AVC-LAN Circuit |
| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the L41 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L41-9 (TX1+) - L41-10 (TX1-) | Always | 60 to 80 Ω |
| *1 | Component without harness connected (Navigation Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT) |
Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
Disconnect all connectors in all AVC-LAN circuits.
Check for an open or short in all AVC-LAN circuits.

|
| ||||
| OK | |
| 3.INSPECT MALFUNCTIONING PARTS |
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
|
| ||||
| OK | ||
| ||