AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit |

| 1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY |
Disconnect the radio and display receiver assembly connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L149-7 (TX1+) - L149-8 (TX1-) | Always | 60 to 80 Ω |
| *a | Component without harness connected (Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT) |
Disconnect the radio and display receiver assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L149-7 (TX1+) - L143-8 (TX+) | Always | Below 1 Ω |
| L149-8 (TX1-) - L143-7 (TX-) | Always | Below 1 Ω |
| L149-7 (TX1+) - Body ground | Always | 10 kΩ or higher |
| L149-8 (TX1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT MALFUNCTIONING PARTS |
Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.
|
| ||||
| OK | ||
| ||