Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM


E226477E10


INSPECTION PROCEDURE

HINT:
The navigation ECU sub-assembly is the master unit.

1.INSPECT NAVIGATION ECU SUB-ASSEMBLY


    E230428E02
  1. Disconnect the navigation ECU sub-assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L130-7 (TX1+) - L130-8 (TX1-)
    Always
    60 to 80 Ω
    L150-3 (TX3+) - L150-4 (TX3-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Navigation ECU Sub-assembly)



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
  1. Disconnect the navigation ECU sub-assembly connector.

  1. Disconnect the stereo component amplifier assembly connector.

  1. Disconnect the parking assist ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L143-8 (TX+) - L130-7 (TX1+)
    Always
    Below 1 Ω
    L143-7 (TX-) - L130-8 (TX1-)
    Always
    Below 1 Ω
    L152-11 (TX+) - L150-3 (TX3+)
    Always
    Below 1 Ω
    L152-10 (TX-) - L150-4 (TX3-)
    Always
    Below 1 Ω
    L143-8 (TX+) - Body ground
    Always
    10 kΩ or higher
    L143-7 (TX-) - Body ground
    Always
    10 kΩ or higher
    L152-11 (TX+) - Body ground
    Always
    10 kΩ or higher
    L152-10 (TX-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal operation.



NG
REPLACE NAVIGATION ECU SUB-ASSEMBLY (Click here)
OK

REPLACE MALFUNCTIONING PARTS