LIGHTING SYSTEM > High Beam Headlight Circuit |

| 1.CHECK OPERATION (LOW BEAM HEADLIGHTS) |
Check the operation of the low beam headlights.
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the high beam headlights illuminate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Head Light Hi | High beam headlights | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT HEADLIGHT DIMMER RELAY (DIM) |
![]() |
Remove the headlight dimmer relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT DIMMER RELAY) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Headlight dimmer relay terminal 2 - Body ground | Always | 11 to 14 V |
| Headlight dimmer relay terminal 3 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY - INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the 2C instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Headlight dimmer relay terminal 1 - 2C-22 | Always | Below 1 Ω |
| 2C-22 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2C-22 - A-22 (DIM) | Always | Below 1 Ω |
| 2C-22 - Body ground | Always | 10 kΩ or higher |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | ||
| ||