Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR


A219103E01
Text in Illustration 
*1
Component without harness connected
(Heated Oxygen Sensor)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    (HT) - (+B)
    20°C (68°F)
    11 to 16 Ω
    (HT) - (E)
    -
    10 kΩ or higher

    If the result is not as specified, replace the heated oxygen sensor.