ECM > INSTALLATION |
| 1. INSTALL ECM |
![]() |
Install the ECM with the 2 bolts.
![]() |
Install the 2 wire harness clamps.
Connect the 2 ECM connectors.
![]() |
Connect the 2 ECM connectors and lower the 2 levers.
Install the 2 wire harness clamps.
![]() |
Install the No. 2 engine room wire with the bolt.
![]() |
Slide the side cover down and engage the 2 claws to install it.
![]() |
Slide the engine room wire harness down and engage the 2 claws to install it.
![]() |
Connect the 3 wire harness connectors.
Install the No. 1 relay block cover.
| 2. INSTALL RADIATOR WITHOUT CAP RESERVE TANK ASSEMBLY |
![]() |
Install the radiator without cap reserve tank assembly with the 2 bolts.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 5. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 6. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 7. PERFORM INITIALIZATION |
Perform Initialization when replacing the ECM .