ECM > REMOVAL |
| 1. PRECAUTION (w/ Navigation System for HDD) |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 6. SEPARATE RADIATOR WITHOUT CAP RESERVE TANK ASSEMBLY |
![]() |
Remove the 2 bolts and separate the radiator without cap reserve tank assembly.
| 7. REMOVE ECM |
Remove the No. 1 relay block cover.
![]() |
Disconnect the 3 wire harness connectors.
![]() |
Disengage the 2 claws, push up the engine room wire harness and separate it from the engine room relay block.
![]() |
Disengage the 2 claws and push up the side cover to remove it.
![]() |
Loosen the bolt and separate the No. 2 engine room wire.
Disconnect the 2 ECM connectors.
![]() |
Disconnect the 2 wire harness clamps.
Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.
![]() |
Separate the 2 wire harness clamps.
![]() |
Remove the 2 bolts and ECM with 2 ECM brackets.