Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR NO. 2 FLOOR BOARD


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. SEPARATE RADIATOR WITHOUT CAP RESERVE TANK ASSEMBLY


    A212304
  1. Remove the 2 bolts and separate the radiator without cap reserve tank assembly.



7. REMOVE ECM
  1. Remove the No. 1 relay block cover.



    A212300
  1. Disconnect the 3 wire harness connectors.



    A212301
  1. Disengage the 2 claws, push up the engine room wire harness and separate it from the engine room relay block.



    A212302
  1. Disengage the 2 claws and push up the side cover to remove it.



    A212303
  1. Loosen the bolt and separate the No. 2 engine room wire.



  1. Disconnect the 2 ECM connectors.



      A212305
    1. Disconnect the 2 wire harness clamps.

    2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



    A212306
  1. Separate the 2 wire harness clamps.



    A212307
  1. Remove the 2 bolts and ECM with 2 ECM brackets.