FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION (w/ Navigation System for HDD) |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 4. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 5. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 7. REMOVE NO. 2 CYLINDER HEAD COVER (w/o EGR System) |
![]() |
Remove the 3 clips and No. 2 cylinder head cover.
| 8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (w/o EGR System) |
![]() |
Disconnect the connector.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose assembly.
Remove the 2 clamps and air cleaner cap sub-assembly.
| 9. REMOVE INLET AIR CLEANER ASSEMBLY (w/o EGR System) |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 10. REMOVE AIR CLEANER CASE (w/o EGR System) |
![]() |
Separate the No. 4 water by-pass hose from the air cleaner case.
Remove the 3 bolts and air cleaner case.
| 11. REMOVE AIR CLEANER HOSE ASSEMBLY (w/o EGR System) |
![]() |
Disconnect the ventilation hose from the cylinder head cover sub-assembly.
Loosen the hose clamp and remove the air cleaner hose assembly.
| 12. REMOVE EGR WITH COOLER PIPE SUB-ASSEMBLY (w/ EGR System) |
| 13. DISCONNECT ENGINE WIRE |
![]() |
Disconnect the 4 fuel injector connectors.
Disconnect the 4 connectors.
Remove the bolt.
Disengage the 2 clamps to disconnect the engine wire.
| 14. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Release the claw and remove the No. 1 fuel pipe clamp.
![]() |
Pinch the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
| 15. SEPARATE NO. 1 WATER BY-PASS PIPE (w/o EGR System) |
![]() |
Disengage the clamp to disconnect the engine wire.
Remove the 2 bolts and nut, and separate the No. 1 water by-pass pipe.
| 16. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt.
![]() |
Remove the 2 bolts and the fuel delivery pipe sub-assembly with the 4 fuel injector assemblies.
| 17. REMOVE NO. 1 DELIVERY PIPE SPACER |
![]() |
Remove the 2 No. 1 delivery pipe spacers from the cylinder head.
| 18. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each fuel injector assembly.
For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector shaft.
![]() |
Remove the 4 injector vibration insulators.