FRONT EVAPORATOR TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL NO. 1 COOLER THERMISTOR |
![]() |
Install the No. 1 cooler thermistor as shown in the illustration.
| Part | Length | |
| A | 175 mm | 6.89 in. |
| B | 161.6 mm | 6.36 in. |
| C | 87.9 mm | 3.46 in. |
| D | 50 mm | 1.99 in. |
| *1 | From Tank |
| *2 | Fixed Part |
| *3 | Sensor Part |
| 2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces.
Install the 2 O-rings to the cooler evaporator sub-assembly.
![]() |
Engage the clamp and install the cooler evaporator sub-assembly with the No. 1 cooler thermistor.
![]() |
Engage the 4 claws.
Install the lower heater case with the 4 screws.
![]() |
Install the packing.
| 3. INSTALL COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
| 4. INSTALL BLOWER ASSEMBLY |
w/o PTC Heater:
Engage the guide.
Install the blower assembly with the 3 screws.
Connect the connector.

w/ PTC Heater:
Engage the guide.
Install the blower assembly with the 3 screws.
Connect the connector.
Engage each clamps.
Install the screw and connect the quick heater connector.

| *1 | Quick Heater Connector | - | - |
| 5. INSTALL AIR CONDITIONING UNIT ASSEMBLY |