STEERING KNUCKLE > INSTALLATION |
| 1. INSTALL STEERING KNUCKLE |
Secure the steering knuckle between aluminium plates in a vise.
![]() |
Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.
![]() |
Apply MP grease to the areas indicated by the arrows in the illustration on the front drive shaft assembly contact surface of the front axle hub sub-assembly.
| *1 | MP grease |
| 2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY |
Secure the front axle assembly in a vise.
![]() |
Install the front lower ball joint assembly to the front axle assembly with the nut.
Install a new clip.
| 3. INSTALL FRONT AXLE ASSEMBLY |