AIR CONDITIONING SYSTEM > Air Conditioning Control Panel Circuit |

| 1.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the A/C control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L20-8 (GND) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to A/C Control Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - BATTERY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L20-5 (IG+) - L20-8 (GND) | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of wire harness connector (to A/C Control Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C CONTROL ASSEMBLY) |
![]() |
Disconnect the A/C amplifier connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-37 (LIN1) - L20-2 (TX+) | Always | Below 1 Ω |
| L17-37 (LIN1) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to A/C Amplifier) |
| *2 | Front view of wire harness connector (to A/C Control Assembly) |
|
| ||||
| OK | |
| 4.REPLACE A/C CONTROL ASSEMBLY |
Replace the A/C control assembly with a known good one and check if the same problem occurs again (Click here).
|
| ||||
| OK | ||
| ||