LIGHTING SYSTEM > Taillight Relay Circuit |


| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Taillight Relay | Taillight relay | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly.
Connect a positive (+) lead from the battery to terminal 2E-1or 2F-1.
Connect a negative (-) lead from the battery to terminal A-14.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2C-10 - Battery negative | Always | 11 to 14 V |
| 2D-18 - Battery negative | Always | 11 to 14 V |
| 2B-7 - Battery negative | Always | 11 to 14 V |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) |
| *2 | for LHD |
| *3 | for RHD |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the 2E or 2F instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2E-1 - Body ground | Always | 11 to 14 V |
| 2F-1 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||