Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Taillight Relay Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.

WIRING DIAGRAM


E191089E10


E241410E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. Check that the relay operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    ON/OFF
    -

    OK:
    Taillight relay operates. (Taillights illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    E191090E01
  1. Remove the instrument panel junction block assembly.

  1. Connect a positive (+) lead from the battery to terminal 2E-1*1 or 2F-1*2.

  1. Connect a negative (-) lead from the battery to terminal A-14.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2C-10 - Battery negative
    Always
    11 to 14 V
    2D-18 - Battery negative
    Always
    11 to 14 V
    2B-7 - Battery negative
    Always
    11 to 14 V

    1. *1: for LHD
    2. *2: for RHD
    Text in Illustration 
    *1
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    *2
    for LHD
    *3
    for RHD



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
  1. Disconnect the 2E*1 or 2F*2 instrument panel junction block assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2E-1*1 - Body ground
    Always
    11 to 14 V
    2F-1*2 - Body ground
    Always
    11 to 14 V

  1. *1: for LHD
  2. *2: for RHD


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)